TSS Ductless System Installation at EWR ATCT (Newark, N.J.)

Description

{"description":" Mechanical \n\n \n\t Install (3) indoor wall-mounted units, along with all refrigerant and drain piping. \n\t Install (1) 6-ton heat pump. Unit to be anchored to exterior concrete wall via on L-bracket steel frame. \n\t Coordinate core penetrations through concrete wall for piping, electrical, and drain lines. Installation to include all wall waterproofing. \n\t Provide and insulate all refrigerants and condensate piping above ceiling \n\t Test and charge system to verify operation. \n \n\n Electrical \n\n \n\t Install new dedicated 208V, 3-phase power circuit \n\t Provide NEMA 4X, 60A non-fused stainless steel disconnect at outdoor unit \n\t Provide power and control conduit and wiring to/from all units \n\t Penetrate concrete wall. \n\t Provide penetration and conduit through roof deck. Patch and flash roof as required to maintain new roof warranty through Carlisle Roof installer. \n \n\n Controls \n\n \n\t Integrate mini-split system into the existing FAA Schneider Electric EcoStruxure DDC system via BACnet \n\t Provide and install one IP-IO module at VAV-17 for coordinated backup cooling enable/disable \n\t Submit point list, graphics, and control narrative to COR for approval. \n\t Program unit set points, and update AHU-3 supply air setpoints \n\t Support commissioning of system to validate operation. \n \n\n Structural & Interior \n\n \n\t Concrete core penetration for pipes and conduits \n\t Provide support framing for all units and steel plates as shown in drawing. \n\t Provide support for pipes and conduits. \n\t Work to include wall restoration and painting. \n \n"} Solicitation Number: TSS_Ductless_System_Installation_EWR_ATCT Type: Sources Sought Base Type: Sources Sought NAICS: 238220 Classification Code: Z1BA Response Deadline: 2025-12-01T12:00:00-06:00 Office Address: FORT WORTH, TX Place of Performance: Newark, New Jersey, 07114 POC: Elisha Distler, elisha.distler@faa.gov, 8172224196 {"description":" Mechanical \n\n \n\t Install (3) indoor wall-mounted units, along with all refrigerant and drain piping. \n\t Install (1) 6-ton heat pump. Unit to be anchored to exterior concrete wall via on L-bracket steel frame. \n\t Coordinate core penetrations through concrete wall for piping, electrical, and drain lines. Installation to include all wall waterproofing. \n\t Provide and insulate all refrigerants and condensate piping above ceiling \n\t Test and charge system to verify operation. \n \n\n Electrical \n\n \n\t Install new dedicated 208V, 3-phase power circuit \n\t Provide NEMA 4X, 60A non-fused stainless steel disconnect at outdoor unit \n\t Provide power and control conduit and wiring to/from all units \n\t Penetrate concrete wall. \n\t Provide penetration and conduit through roof deck. Patch and flash roof as required to maintain new roof warranty through Carlisle Roof installer. \n \n\n Controls \n\n \n\t Integrate mini-split system into the existing FAA Schneider Electric EcoStruxure DDC system via BACnet \n\t Provide and install one IP-IO module at VAV-17 for coordinated backup cooling enable/disable \n\t Submit point list, graphics, and control narrative to COR for approval. \n\t Program unit set points, and update AHU-3 supply air setpoints \n\t Support commissioning of system to validate operation. \n \n\n Structural & Interior \n\n \n\t Concrete core penetration for pipes and conduits \n\t Provide support framing for all units and steel plates as shown in drawing. \n\t Provide support for pipes and conduits. \n\t Work to include wall restoration and painting. \n \n"}