Z2DZ--Bolt Replacement Survey ASTM A307

Description

{"description":"\nOklahoma City Veterans Affairs Health Care System \nASTM307 Bolt Replacement Survey\n\n\nI. GENERAL:\n\nThis project is to survey and identify locations of ASTM 307 bolts and develop a replacement plan to replace the bolts with the required ASTM A193 at the OKC VA HCS at Oklahoma City, Oklahoma. \n\nThe contractor is fully responsible for verifying and validating all information contained within this statement of work. Contractor must fully evaluate the condition of the existing structures and verify the current condition of the project site. \n\nAll measurements/quantities provided in this document are approximate and are to be used for reference only. The contractor will be responsible for taking on-site measurements and verifying all quantities and distances.\n\nAll materials/fasteners/etc. must be new and provided by the contractor unless otherwise specified.\n\nThe contractor shall abide by all Safety, Security and Infection Control Policies and Procedures of the Oklahoma City VA HCS. \n\nVA facilities are tobacco free. No smoking is permitted on VA property. The contractor is responsible for their subcontractor s compliance with this policy.\n\nAll work must conform to, and comply with, the latest edition/version of ALL applicable VA, federal, state, and local laws, rules, regulations, codes, and standards.\n\nII. JUSTIFICATION: \n \n Per VHA directive, All VAMCs must complete a survey of their existing steam and hot water piping systems and develop a replacement plan, prioritizing high and medium pressure steam and hot water piping systems operating at over 50 pounds per square inch. If ASTM A307 bolts (all grades) are identified, an Interim Safety Measure must be developed to ensure the safety of staff and the facility until replacement is complete.\n\nIII. STATEMENT OF WORK:\n\n The contractor shall provide supervision, manpower, and materials to provide a replacement plan to replace ASTM A307 bolts currently installed in the facility to the required ASATM A193 bolts as the appropriate fastener for steam and hot water piping.\n\nContractor shall locate and document all ASTM 307 bolts that are installed on high and medium pressure steam and hot water piping\nAreas to inspect include: 73 Air handling units, Penthouse 8th floor mechanical room, BF118 Mechanical Room, Emergency Room Mechanical Room, Research building Mechanical Room, Sub-basement Mechanical Room, 1st floor Mechanical Room, 2nd floor Mechanical Room, 3rd floor Mechanical Room, 5th floor Mechanical Room and Central Boiler Plant.\nContractor to cut and remove insulation from flanges that are covering the bolts\nContractor shall prioritize replacement plan from high and medium pressure steam and hot water piping systems operating over 50 pounds per square inch. \nContractor shall provide report consisting of locations of ASTM 307 bolts with quantities at each equipment\nIMPORTANTR NOTE: This RFI (Request for Information) is for information only.\nNo award will be made from this RFI. \n\nPlease communicate via e-mail to frances.basham@va.gov by 15:00 on 10/24/2025 as to your company s ability to perform service per this brief Scope of Work. \n\nIf interested, please provide the following:\nPlease state your company s business size \nPlease provide SAM UEI number\nIf you have a FSS/GSA contract that includes this service \nProvide FSS/GSA contract number if applicable \n\n\n\n"} Solicitation Number: 36C25926Q0034 Type: Sources Sought Base Type: Sources Sought NAICS: 236220 Classification Code: Z2DZ Response Deadline: 2025-10-24T15:00:00-05:00 Office Address: Greenwood Village, CO Place of Performance: Oklahoma City, Oklahoma, 73104 POC: Frankie Basham, frances.basham@va.gov, 918-577-3923 {"description":"\nOklahoma City Veterans Affairs Health Care System \nASTM307 Bolt Replacement Survey\n\n\nI. GENERAL:\n\nThis project is to survey and identify locations of ASTM 307 bolts and develop a replacement plan to replace the bolts with the required ASTM A193 at the OKC VA HCS at Oklahoma City, Oklahoma. \n\nThe contractor is fully responsible for verifying and validating all information contained within this statement of work. Contractor must fully evaluate the condition of the existing structures and verify the current condition of the project site. \n\nAll measurements/quantities provided in this document are approximate and are to be used for reference only. The contractor will be responsible for taking on-site measurements and verifying all quantities and distances.\n\nAll materials/fasteners/etc. must be new and provided by the contractor unless otherwise specified.\n\nThe contractor shall abide by all Safety, Security and Infection Control Policies and Procedures of the Oklahoma City VA HCS. \n\nVA facilities are tobacco free. No smoking is permitted on VA property. The contractor is responsible for their subcontractor s compliance with this policy.\n\nAll work must conform to, and comply with, the latest edition/version of ALL applicable VA, federal, state, and local laws, rules, regulations, codes, and standards.\n\nII. JUSTIFICATION: \n \n Per VHA directive, All VAMCs must complete a survey of their existing steam and hot water piping systems and develop a replacement plan, prioritizing high and medium pressure steam and hot water piping systems operating at over 50 pounds per square inch. If ASTM A307 bolts (all grades) are identified, an Interim Safety Measure must be developed to ensure the safety of staff and the facility until replacement is complete.\n\nIII. STATEMENT OF WORK:\n\n The contractor shall provide supervision, manpower, and materials to provide a replacement plan to replace ASTM A307 bolts currently installed in the facility to the required ASATM A193 bolts as the appropriate fastener for steam and hot water piping.\n\nContractor shall locate and document all ASTM 307 bolts that are installed on high and medium pressure steam and hot water piping\nAreas to inspect include: 73 Air handling units, Penthouse 8th floor mechanical room, BF118 Mechanical Room, Emergency Room Mechanical Room, Research building Mechanical Room, Sub-basement Mechanical Room, 1st floor Mechanical Room, 2nd floor Mechanical Room, 3rd floor Mechanical Room, 5th floor Mechanical Room and Central Boiler Plant.\nContractor to cut and remove insulation from flanges that are covering the bolts\nContractor shall prioritize replacement plan from high and medium pressure steam and hot water piping systems operating over 50 pounds per square inch. \nContractor shall provide report consisting of locations of ASTM 307 bolts with quantities at each equipment\nIMPORTANTR NOTE: This RFI (Request for Information) is for information only.\nNo award will be made from this RFI. \n\nPlease communicate via e-mail to frances.basham@va.gov by 15:00 on 10/24/2025 as to your company s ability to perform service per this brief Scope of Work. \n\nIf interested, please provide the following:\nPlease state your company s business size \nPlease provide SAM UEI number\nIf you have a FSS/GSA contract that includes this service \nProvide FSS/GSA contract number if applicable \n\n\n\n"}